bellasonic
New Member
All,
New Ultra owner (6.10) and I'm simply trying setup an Ernie Ball Volume pedal as described in the owners manual. Pedal 1 on axe to EB, input volume or output 1 volume (I tried both) in I/O set to pedal 1. It does work but the volume with the pedal all the way down is at maybe 50-60%. I've tried the pedal 1 calibrate but no change. Setting the input or output volume back to none and turning the unit off/on is then the only way I can get the original volume level back.
I found several posts with folks trying to use these as expression pedals but nothing about just using them as volume pedals. Perhaps I still need to use the insert cable or add a volume block to my patches?
Sorry if this has been covered before and thanks for any help.
New Ultra owner (6.10) and I'm simply trying setup an Ernie Ball Volume pedal as described in the owners manual. Pedal 1 on axe to EB, input volume or output 1 volume (I tried both) in I/O set to pedal 1. It does work but the volume with the pedal all the way down is at maybe 50-60%. I've tried the pedal 1 calibrate but no change. Setting the input or output volume back to none and turning the unit off/on is then the only way I can get the original volume level back.
I found several posts with folks trying to use these as expression pedals but nothing about just using them as volume pedals. Perhaps I still need to use the insert cable or add a volume block to my patches?
Sorry if this has been covered before and thanks for any help.