fuzzyoctaves
Inspired
![Screenshot 2024-05-26 at 9.43.59 AM.png Screenshot 2024-05-26 at 9.43.59 AM.png](https://forum.fractalaudio.com/data/attachments/129/129549-25c75b3002d1f267cae76640dfe4fe91.jpg)
This template is a WiP - my end state goal is to use Mixer 1 to blend my dry signal with multiple wet paths. I have run into a snag and would appreciate any advice:
Out4 > In4 are going through an external stereo pedal with no effects on. So In4 is essentially the same signal as Out4, which is essentially the same signal just after the Cab.
If I set Row 6 to 50% and Row 3 to 50%, I get a signal that sounds like a flange effect - I am assuming that this is a phase issue? I have tried reversing the Out4/In4 cables and my next step is to simply route a pair of cables from Out4 to In4. Before I get that deep, I wanted to check to see if I am missing something obvious or if there is some limitation in the Axe that I am unaware of.