parallel paths ques

[chrisjnyc]

Anyone know how to setup a patch where I have all the AX8 effects (drive, delay, etc)going into my Hayseed amp via the FX loop, (except verb) and the amp and cab sims are going out via the main outputs... The key here is I need to have the AX8 reverb going after the amp block. and still in the (real) amp path...

 

[iaresee]

The key here is I need to have the AX8 reverb going after the amp block. and still in the (real) amp path...

That's going to be a sticking point. How can you take the output of the REV block and have it contain both AMP+CAB simulated and non-sim'ed signal? Thought pretty hard about that and I couldn't come up with a way to make this happen.

 

[cataclysm]

Hmm tough one...if only the AX8 had the ability to create Bus sends!