Panning with amps in parallel into one cab

[Johnkenn]

Didn't see an answer to this. If I set up two amps parallel going into one cab...I pan one to the left and one to the right...but I'm really only getting volume changes...more volume when left and less when right. I would have assumed it would be one amp all the way left channel and another all the way right. Why is that?

 

[chris]

check your Cab block Input settings.

 

[sprint]

For hard panned parallel amps to maintain full stereo thru a cab block, your cab needs to have stereo input and the 1st + 2nd cab slots occupied, and panned hard left / right respectively (or 4 cab slots occupied and panned hard left / right / left / right)

 

[unix-guy]

Also are you using 2 IR slots?

 

[mr_fender]

...and hard panning those cabs to maintain stereo separation. Cabs 1 and 3 are fed by the left channel and cabs 2 and 4 are fed by the right channel when in stereo input mode.

 

[sprint]

...and hard panning those cabs to maintain stereo separation. Cabs 1 and 3 are fed by the left channel and cabs 2 and 4 are fed by the right channel when in stereo input mode.

+1 - a tad tricky when you want the same 2 IR mix (A+B) on both sides while maintaining full stereo from previous block:

• IR A in slot 1 panned left.
• IR B in slot 3 panned left.
• IR B in slot 2 panned right.
• IR A in slot 4 panned right.

 

[Piing]

Also, you cannot stereo-pan the pairs of cabs 1/3 or 2/4