pan hard left and hard right

[mniel8195]

How do i pan two amps to two sides of stero 4X12 do i have to connect the mixer to both signals?

 

[Ant Music]

good question. bump.

 

[Bakerman]

Set the amps' balance controls left & right. See factory preset 93 (U.S. vs. U.K.) for an example.

 

[krmtsr]

Set the amps' balance controls left & right. See factory preset 93 (U.S. vs. U.K.) for an example.

I actually had the same question but slightly different.. how do I pan 2 cabs hard left and hard right?

I tried to mess with the "bal" setting but it did not do the trick for me, for some reason I was still getting signal from the opposite channel despite panning hard left or hard right

 

[Bakerman]

I actually had the same question but slightly different.. how do I pan 2 cabs hard left and hard right?

I tried to mess with the "bal" setting but it did not do the trick for me, for some reason I was still getting signal from the opposite channel despite panning hard left or hard right

Balance of mono cabs or Pan L & Pan R w/ stereo mode will pan them. With 2 mono cabs after stereo effects you need a couple blocks (like vol, filter, mixer) to mute one channel prior to each cab to keep the effects heard in stereo. It's tough to know what else might have been happening without seeing the preset.