Output Jacks causing Volume Problem!

C

CountOfTuscany

New Member
Hi guys got an AX8 used...
When I use the main output 1, with the cable all the way in into the AX8 the volume is low.
When i pull the cable out slightly, the volume increases higher.
(1/4'')

I'm guessing this isnt normal right?
cables are fine, no issues on that.
 
this is normal. it is not a problem when used correctly.

push the cable in all the way like you would any other device. the 1/4" outputs are Humbuster TRS jacks. do not pull them out slightly for more volume.
 
Is it possible to apply a Control Switch to the Humbuster Cable that would pull it out of the jack 1/32 of an inch, for leads?
:D
 
geetarplayer said:
Is it possible to apply a Control Switch to the Humbuster Cable that would pull it out of the jack 1/32 of an inch, for leads?
:D
Click to expand...
as humorous as this is, there are many ways to increase for a lead boost or just more level in general.

there should be no reason to need to do this "trick" to get volume. it's not intended and improper use.
 
chris said:
this is normal. it is not a problem when used correctly.

push the cable in all the way like you would any other device. the 1/4" outputs are Humbuster TRS jacks. do not pull them out slightly for more volume.
Click to expand...
Beautiful....good to know this....couldnt be happier with the tones....thank you....
 
You must log in or register to reply here.
Back
Top Bottom