Output 2 disabled when using input2?

[gdgross]

In electric land, I run normally - front side input, output 1 to FOH, output 2 to poweramp/monitor. (I use the copy output1 to output2 function.)

In acoustic land, I run a TRS cord into input 2 (L and R, two pickups in my acoustic, this way they can be eq'd and compressed independently in the axe and then combined) and route my signal that way. I often don't have to use my own poweramp and monitor in acoustic situations, but this weekend I did.

When using input 1 and electric, I was able to get sound out of output 2 and into my monitor no problem. When using acoustic (and input 2) it seemed like output 2 was disabled; I got no sound out of the axe-fx into my monitor. Output 1 worked fine however, the FOH was fine.

Any ideas? Is this a bug; am I fooling the axe fx into thinking I'm using the loop and somehow it disables output 2?

Thanks!

 

[Bakerman]

Output 1 is never copied to Output 2 if the FXL block is used, so you'd need to add feedback send & return blocks:

----RTN--FXL--(any effects used)--SND--|

Turn RTN mix to 100%... 0 is the default and will result in no sound.

 

[gdgross]

Ok, thanks!