OK it has been awhile since my last firmware update and I have a question

W

webe123

Inspired
I just went from firmware 10.0 to QUANTUM 10.01. I even loaded the latest presets for all the banks and am loving the sounds.....but I used to be able to control the volume of a preset by going to the layout button on the front panel and then going to the last screen and I could control the volume for the preset there....but it is not that way in the new firmware! How do I control the main volume for each preset? I want to get the ones I use to all have pretty much the same volume....so when it goes through the PA, I do not have sounds that are way up or way down in volume.
 
the best way to balance Preset levels is to use the VU meter and adjust the Amp block Level.

 
Thanks so much! This was not on version 10...it was not made available until version 18 and above came out apparently.
 
Last edited:
You must log in or register to reply here.
Back
Top Bottom