simonp54
Experienced
It appears that when I use a stand in switch, the only CS MIDI that gets transmitted is the associated CS payload for the TAP function. -!- corrected slightly below.
Config:
CS 1 a control change
CS 2 another (different) control change
Button 7 on Layout 2 TAP = CS1
Button 7 on Layout 2 HOLD = CS2
I'm seeing the MIDI payload for CS1 no matter whether I tap or hold. I never see MIDI payload for CS2. -- CORRECTION... I'm seeing the MIDI payload for the LAST added function no matter whether I tap or hold. (i.e. if the HOLD CS assignment is made after the TAP CS assignment, i see the HOLD CS fire no matter whether actually tap or hold the button.) this behaviour is reversed if the TAP CS assignment is made after the HOLD CS assignment)
Also the "state" of the LEDs appears wrong. I'm using these in a Momentary fashion, so the LED should only light when the button is pressed. This does not happen and the LED remains ON after release, and toggles in the opposite manner, but isn't correctly following the FC as it should.
all on latest FW for both FCs and AxeFX3. (aka 1.09 and FW 7.00 and AxeEdit 1.03.01)
Edit: i've also [i thought i did!!!] tried the "reverse polarity" setting for these buttons, but it made no difference. (They are Mosky switches that a lot of people are using successfully)
second edit: the reverse polarity setting is massively important for this to function correctly. I have it working now I believe.
Config:
CS 1 a control change
CS 2 another (different) control change
Button 7 on Layout 2 TAP = CS1
Button 7 on Layout 2 HOLD = CS2
I'm seeing the MIDI payload for CS1 no matter whether I tap or hold. I never see MIDI payload for CS2. -- CORRECTION... I'm seeing the MIDI payload for the LAST added function no matter whether I tap or hold. (i.e. if the HOLD CS assignment is made after the TAP CS assignment, i see the HOLD CS fire no matter whether actually tap or hold the button.) this behaviour is reversed if the TAP CS assignment is made after the HOLD CS assignment)
Also the "state" of the LEDs appears wrong. I'm using these in a Momentary fashion, so the LED should only light when the button is pressed. This does not happen and the LED remains ON after release, and toggles in the opposite manner, but isn't correctly following the FC as it should.
all on latest FW for both FCs and AxeFX3. (aka 1.09 and FW 7.00 and AxeEdit 1.03.01)
Edit: i've also [i thought i did!!!] tried the "reverse polarity" setting for these buttons, but it made no difference. (They are Mosky switches that a lot of people are using successfully)
second edit: the reverse polarity setting is massively important for this to function correctly. I have it working now I believe.
Last edited: