Raca
Experienced
This new parameter has only 3 values on the Axe-Fx: 2-4-6.
But while working on the xml files of the old Lars editor to update them to firmware 8.08, I discovered that the Axe-Fx wants 4 values in the sysex message. The first two values both correspond to "2" on the Axe-Fx, the third is "4" and the fourth is "6".
My workaround was to put 4 values as shown on the screen capture below.
But while working on the xml files of the old Lars editor to update them to firmware 8.08, I discovered that the Axe-Fx wants 4 values in the sysex message. The first two values both correspond to "2" on the Axe-Fx, the third is "4" and the fourth is "6".
My workaround was to put 4 values as shown on the screen capture below.