MFC IAs light up but don't function after installing FW10?

M

mark.oswald

Member
I can press the switches and the lights go on and off, but the effect block never changes state from what's initially set up in the preset. If it helps diagnose, the tuner switch/display on the MFC doesn't seem to work either, but if I hit the tuner button on the AFX front panel, then it works fine. The edit/setup/etc switches seem to work from what I can tell.

I did the AFX system reset and reset the MFC as well - no help.

I'm guessing/hoping this is one of those really basic/simple things that I just missed. Haven't had to dig into setup much previously because it all just kinda worked out of the box.

Posting this in the AFX II discussion (not MFC) because this worked just fine before upgrading firmware.

Thanks for your suggestions!!
 
Nevermind... Came across other threads that discussed this bug. Just had to switch between patches using the MFC and that seems to clear the problem. Apparently this must be done each time you reboot the MFC.
 
You must log in or register to reply here.
Back
Top Bottom