@jasonmi3 caught in the latest that it had the older Deluxe Reverbs in Bank 2 without the updated negative feedback values and missing Out3 and Out4 and labeled as FM3. My bad. Will be fixed in next 30 minutes. Have not emailed anyone yet.
Any other "catches" before I do this?
The new FC-12 layout is included, and I'm open to feedback, It's still a work in progress but should let you access the Kicker Coil and the Cs32 amp boost and move between presets, scenes, efx and amp page and looper easily. I left PERFORM in page 8 mostly blank for you to make your own (or write over my PERFORM in page 8).
IfI have time I'll do a video on the FC-12 layout...but not for a few weeks, that also lest me hear from ya'll about what isn't working for you with it or problems. Just look on the Axe-III editor under FC Controllers button (goes yellow) then Layouts (left side) for each Layout Page 1 to 9, at all the pages and you'll get a good sense of them.
Whenever you see a "slash" "/" mark and lower case, that means the HOLD function is indicated after the slash mark.
Examples:
EXF1/Mstr means TAP will take you to Effects main page, and HOLD will take you to the Master Layout.
Tap BPM/Tnr is Tap delay for TAP, but HOLD on this switch will bring up the tuner.
So here are some Layout pages...
I made it so for ANY Scene, just HOLD that Scene and the CS2 Amp Boost will come on - easy!
Presets all have the 5.1db Single Coil "Kicker Coil" boost built in with a HOLD, so if you play a Strat or Tele, that's a fast way to turn that on in the preset. It doesn't stick if you changed scenes in Scenes 1-4 though, but it's on usually in Scenes 5-8.
There are two effects pages. The first one covers most of what you'll need for the LiveGold presets. You can also add your own Drive1 and it's there. If you HOLD an effects switch, it will cycle between channels A B C D so you can try out different effects. The LED screen will tell you what block channel you are going to while you HOLD and cycle.
There's a second EFX page and you can customize it (or any). This shows lesser used effects. It also lets you raise the noise gate up if an amp is buzzing too loudly to the next noise gate channel.
The Looper page is unchanged. The Amp Controller page lets you access the Controller Switches CS2, CS3, CS4, CS5, and CS6. You can also raise or lower Amp1's LEVEL by +/- 1db here too, which is convenient.
I used the default colors for switches from the FC-12 manual throughout, you can change them such as for effects.
Here is the PERFORM 1 page. One possible change you make is having all the other pages go to this PERFORM1 (Layout 7) page rather than the Master 9 layout page -- Ill let you figure out what works best for you!