This has been discussed here:
http://forum.fractalaudio.com/axe-fx-ii-discussion/46952-time-synched-fx-placed-correctly-beat.html
I tried to control the LFO RUN parameter with the ENVELOPE controller. It works but whenever the LFO is turned OFF by the envelope, it stays in the same position that it stopped in rather than resetting to the original starting position. When turned back ON the LFO starts from the same position it stopped at.
It would be great to be able to reset the LFO so that it could be synced via controllers like ENVELOPE. Apparently the Ultra works that way?
Thanks for the great firmware updates! 5.04b is killer!
http://forum.fractalaudio.com/axe-fx-ii-discussion/46952-time-synched-fx-placed-correctly-beat.html
I tried to control the LFO RUN parameter with the ENVELOPE controller. It works but whenever the LFO is turned OFF by the envelope, it stays in the same position that it stopped in rather than resetting to the original starting position. When turned back ON the LFO starts from the same position it stopped at.
It would be great to be able to reset the LFO so that it could be synced via controllers like ENVELOPE. Apparently the Ultra works that way?
Thanks for the great firmware updates! 5.04b is killer!