Wish It's there, my screw-up! (Please add pitch +/- indicator for Pitch Control on Performance Page)

bchulse

bchulse

Inspired
Hi,
I use the Pitch Control on the Performance Page. When I need to pitch up/down,
I enable using either a Footswitch or Bypass on/off on Front Panel, then use the Pitch control
to pitch up/down as needed. But there is no indication on this switch to let you know
where the pitch is at. It's a pretty small display with no Zero indicator on the Control.
I often have to do this quickly between songs and it's very difficult to set to correct pitch
just by eye.

A +/- value (like the Pitch control has on the Pitch Block page) would be so much easier.
Thank you for your consideration!
 
Which pitch block type and parameter are you referring to? I'm seeing the value displayed for any parameter that would alter pitch here: Whammy control, VC & Chromatic/Diatonic shift/harmony values, master pitch, detune. (The page shows the value of the parameter you last selected or adjusted above the virtual knobs.)
 
Sorry, Virtual Capo. just used for Pitching up/Down. The Value does not
show on my Performance Page, just the Control itself.
 
Running latest FW (23.PB4). Man, if that's where the indicator is,
I feel like a complete turd! Did not see that at all. Was looking
just above the control itself! Dumbass!

I just need to open my eyes, Bakerman, thank you!
 
You must log in or register to reply here.
Back
Top Bottom