Factory Cab #122 is the same cab, Triptik Mix I think it's called.
I have the OBOT pack & LOVE it. Unfortunately no clips though, I haven't recorded in a long time.
Correct, but I was told that it was indeed the same cab & speaker that is in the OBOT pack. But you are correct, it's not from that pack it was an IR from earlier. Correct this if this is bad info?IIRC that stock cab is from an earlier Cab pack: #5. Not from the Obot pack.
The Obot pack is an excellent pack.
Not sure exactly what or should I say where the letters pertain to as far as mic placement goes, but like iaresee said, use your ears. I'd say all the "A's" would be a group, with different mics but similar mic placements and so on for "B's" & "C's"...I have bought the pack !
I don't play with my AX8 today, but question: In this pack , we have some Letter like A, B, C, etc... for each Mic.
But we have no information about them.
Center to off center ? other ?
Thank you.
I don't think you'll regret it. I use the Carol Ann Scholz Speaker Cab for a lot of different amps. I just loaded up FW 8.1 earlier this morning and wanted to create a few fresh patches for some tunes I'm playing & one of them is, "Helipad" by Andy Timmons. He uses a Mesa Lone Star, so I fired that up & went thru a few Mesa IR's & just for the hell of it I clicked on one of the OBOT Carol Ann IR's and it was quite literally 90% "there." And that was before touching a single dial on the amp.I have bought the pack !
Too many choice in the Caroll AnnI don't think you'll regret it. I use the Carol Ann Scholz Speaker Cab for a lot of different amps. I just loaded up FW 8.1 earlier this morning and wanted to create a few fresh patches for some tunes I'm playing & one of them is, "Helipad" by Andy Timmons. He uses a Mesa Lone Star, so I fired that up & went thru a few Mesa IR's & just for the hell of it I clicked on one of the OBOT Carol Ann IR's and it was quite literally 90% "there." And that was before touching a single dial on the amp.
Anyway, hopefully you'll find the IR's as good as I have.. fwiw, I have used CabLab with of them to create a few mixed IR's I like a lot too.