How to get a fast AutoWha

N

nickxmix

Inspired
I have the AutoWha working using LFO but I need to adjust speed as I can't adjust the LFO speed.
Is there anyway of doing this. I need say between 5Hz - 10Hz. Like a fast tremolo.
I went thru previous post where the same question came up and was answered using only the LFO.
I need the sound used on the old "Bread" classic song "If". I can get close using Rotary & Phaser but it sounds like it should be
AutoWha.
Thanks nickxmix
 
LFO1 & LFO2 rate goes from 0.05 Hz to 30 Hz. If you need a wider range than that, there's something seriously wrong.

Hit the Control button on the front panel to adjust the controller parameters or in Axe Edit hit the controllers button on the left center of the screen.
 
Last edited:
Thank You Mr_fender that's exactly the answer I needed. So far I had only used the controllers page for scene changing
and had not taken notice of the other components available on that page.
So thank you again for pointing me in right direction. I now have the sound I was after. This forum is so full answers to just about everything about our
beloved AXE-Effects.
Cheers to all who are willing to share their knowledge.
 
You must log in or register to reply here.
Back
Top Bottom