1. We would like to remind our members that this is a privately owned, run and supported forum. You are here at the invitation and discretion of the owners. As such, rules and standards of conduct will be applied that help keep this forum functioning as the owners desire. These include, but are not limited to, removing content and even access to the forum.

    Please give yourself a refresher on the forum rules you agreed to follow when you signed up.
    Dismiss Notice

[HELP NEEDED] Axe-Fx ULTRA + G-System : 4CM method

Discussion in 'Rigs and Routing' started by DemolitionColorScheme, Aug 18, 2018.

  1. DemolitionColorScheme

    DemolitionColorScheme
    Expand Collapse
    Inspired

    Joined:
    Jun 9, 2011
    Messages:
    219
    Likes Received:
    11
    Location:
    The Netherlands, Noord-Brabant, Tilburg
    A while ago, all my gear was stolen and now I'm slowly acquiring my old setup again.
    It's been a while since I hooked up a system, so I'm kinda having a brainfart. How do I hook my G-System and Axe-FX ULTRA up in a 4CM-style?

    [​IMG]

    To clarify:
    From what I remember, I used to run the G's preamp effects and pedals in front of the Axe and using the G's time-based effects in the FX loop of the Axe. The Axe outputs will go to a stereo poweramp.

    So, from what I remember, I think it started like this:
    Guitar -> Wireless Sender
    Wireless Receiver -> G-System Input
    G Insert Send -> Axe Input (Left)
    ???
    ???
    ???
    ???
    (brainfart)
    Axe-FX outs -> Stereo Power Amp

    Any help would be appreciated!
     

Share This Page