Smilzo
Fractal Fanatic
I made a wish for solo mode, many suggested to use CS. So I give it a try, but problems arise almost suddenly!
Actual scenario: I use scenes: 4 rythm (S1.4), 4 "solo/lead" versions (S5 is solo version of S1, and so on). Each rythm scene use a different amp channel.
I Have external FS on port 2 (1 is for exp for wha/volume)
I started with clean (S01), go to amp level modifier, set source port 2, set min/max as needed, than move to compression, bla bla bla... work well, I can activate a "solo sound".
Then move to S02. Sound was off. First thing I notice, amp level was already modified! Amp is different, channel is different... but the modifier was there!
How can I set a different min/max value modifier for each channel? There's some tricks?
Attached original preset without controller to use as reference, and messed up one with controller. FW is 6b2
Actual scenario: I use scenes: 4 rythm (S1.4), 4 "solo/lead" versions (S5 is solo version of S1, and so on). Each rythm scene use a different amp channel.
I Have external FS on port 2 (1 is for exp for wha/volume)
I started with clean (S01), go to amp level modifier, set source port 2, set min/max as needed, than move to compression, bla bla bla... work well, I can activate a "solo sound".
Then move to S02. Sound was off. First thing I notice, amp level was already modified! Amp is different, channel is different... but the modifier was there!
How can I set a different min/max value modifier for each channel? There's some tricks?
Attached original preset without controller to use as reference, and messed up one with controller. FW is 6b2