Ground Control Pro & Instant acsess button lights

[ajnord32]

Hello AXE-mates

I`ve set up my GCP for 4 preset. The 8 instant acsess are dedicated (for now) to aktivate/deaktivate effects ... like stomps.

I`d like the lights on the active effekts to be active when I hit a preset (Now the light shows after i`ve pressed once or twice on the button )

Can this be done?

Reg AJJ

 

[Izzyprad]

Yes it can be done.

>Select the preset
>Go to Edit mode (Not setup mode) by pressing Edit button for 2-3 sec
>Then turn all the effects that you want to be On.
>Then Exit
>Save

 

[ajnord32]

Thanks a lot man..(I`ve had the GCP about a week and I`ve been struggeling with the manual) Do you repet this prosess for every preset?
So i check in the grid what i actually active and then press these buttons as you explained?
Do you know how many banks i can use .. when I get to 9 i tarts with letters
Reg
AJJ Norway

 

[Izzyprad]

I am not sure. I think you can only use 8 banks.

 

[ajnord32]

I did about as you explained and it worked out just fine : - )
Thanks man
Reg
AJJ

 

[darrenw5094]

Yes it can be done.

>Select the preset
>Go to Edit mode (Not setup mode) by pressing Edit button for 2-3 sec
>Then turn all the effects that you want to be On.
>Then Exit
>Save

Just wanted to fix this slightly.

Select the Preset
Then turn on all the I/A effects that should be lit
Press and hold 'Edit'
Press edit again
Press Yes/4

 

[darrenw5094]

Not sure about that. I must try it. I thought the GCP can only send info, but it would be handy to have it receive also.