Getting a dry signal when using 2 amp setup.

M

Maqbrown

Member
Not sure what I'm doing wrong but I'm creating a preset with 2 high gain amps and 2 cabs running parallel in the chain. When both amps and cabs are on everything sounds good but when I choose one or the other I get this clean/dry overtone mixed with the overdriven amp that just sounds strange. I assume I'm getting a dry signal from the amp I'm bypassing and obviously the high gain tone from the amp I'm using but I'm not sure.
 
your Amp blocks' bypass modes are set to Thru most likely. so when you turn off the amp, it still passes the signal Thru.

change them to Mute something.
 
You must log in or register to reply here.
Back
Top Bottom