FXL Loop Scene VOL Levelling

[chris]

Chris,
Thanks for the sugggestion. I will try that for sure.

So if all the scene levels are at 0. And the patch levels are level by adjusting amp level, and watching VU.
OUT 2 will also be the same ? Level ?
Thanks

Just to clarify - you can’t change Amp level per Scene. In my situation, I use EQ blocks to adjust for different lead tones and levels.

 

[teddis]

Hi Chris,
Okay, I took your route. Reset all scene sliders to Zero. then adjusted each scene VOL by VU, using amp volume and Filter blocks.
So OUT2 2 should directly reflect this now....be the same vol level ? Remember OUT 2 for me is a FXL block before CAB.

thank you,

 

[Sonofiam]

Hi Chris,
Okay, I took your route. Reset all scene sliders to Zero. then adjusted each scene VOL by VU, using amp volume and Filter blocks.
So OUT2 2 should directly reflect this now....be the same vol level ? Remember OUT 2 for me is a FXL block before CAB.

thank you,

The volumes at OUT 1 and OUT 2 will reflect the same volume increase or decrease per scene, caused by changes made in any effects before the FX Loop block.