Fryette Power Station II Question

C

Casselton

Member
I recently purchased a Power Station II. I am using it as a stand-alone amp with my AXE FX II at my house. So far I am really impressed with the sound. I am a little unclear as to whether the PS II give you a flat non-colored sound. I want to make sure I am doing everything correctly to get a non-colored sound which replicates the sound of the AXE FX II using the PS II. Unfortunately I do not have a flat cab. I am using an
Orange Amplifiers PPC Series PPC112 60W.

Any good suggestions from the experts using the PS II or rules of thumb to get a good replicated sound?

I have also used the PS II with my Randall RT2/50. Once again, very please with the results.

Mark
 
PS II:
- Use the Line In connection. (and a HumBuster Cable)
- Turn Presence and Depth fully CCW.
- Set the switches to the "flat" position.
- Make sure to set the Impedance switch to the correct position for your cab.

I found that it's best to neutralize the Resonance settings in the Amp block, to prevent over-emphasis of bass and treble.
 
yek said:
PS II:
- Use the Line In connection. (and a HumBuster Cable)
- Turn Presence and Depth fully CCW.
- Set the switches to the "flat" position.
- Make sure to set the Impedance switch to the correct position for your cab.

I found that it's best to neutralize the Resonance settings in the Amp block, to prevent over-emphasis of bass and treble.
Click to expand...

You mean by neutralize- set to zero?
 
You must log in or register to reply here.
Back
Top Bottom