FM3 and 4cm with PS1100

[catscanman82]

I don’t know if this has been ask but can I use my FM3 with my combo amp and 4cm and connect my PS100 to FM3 all at the same time so I can use amp modeling and effects for my combo amp. Thanks in advance

 

[Greg Ferguson]

Did you read chapter 4 in the manual? It's all about ways to connect the modeler in real-life scenarios.

 

[catscanman82]

Thanks for the heads up. Maybe I missed that one part.

 

[laxu]

Something like this:

1. Guitar -> FM3 In 1.
2. FM3 Out 1 L -> amp input.
3. Amp speaker out -> PS-100 amp in.
4. PS-100 fx send -> FM3 In 2 L.
5. FM3 Out 2 L -> PS-100 fx return.

Then in the FM3 preset you decide:

1. Route fx to Out 1 to run them into your combo's input.
2. Route fx between In 2 and Out 2 to have a post-amp effects with your combo, for example delay/reverb.
3. Route from In 1 -> fx/amp blocks -> Out 2 to use the FM3 only.

Note that using the Line in on the PS-100 is not an option in this setup. Connecting Line in will mute Amp in.

 

[catscanman82]

Something like this:

1. Guitar -> FM3 In 1.
2. FM3 Out 1 L -> amp input.
3. Amp speaker out -> PS-100 amp in.
4. PS-100 fx send -> FM3 In 2 L.
5. FM3 Out 2 L -> PS-100 fx return.

Then in the FM3 preset you decide:

1. Route fx to Out 1 to run them into your combo's input.
2. Route fx between In 2 and Out 2 to have a post-amp effects with your combo, for example delay/reverb.
3. Route from In 1 -> fx/amp blocks -> Out 2 to use the FM3 only.

Note that using the Line in on the PS-100 is not an option in this setup. Connecting Line in will mute Amp in.

Thanks so much for your help. I Will give it a try.