Firmware with midi usb interface

The plastic on some MIDI cables can be too wide for a connector to get deep enough into the Axe. I had that problem with a cable in the past. Those 2mm (depth & width) can make the difference.

Not sure you can even use FractalBot for normal MIDI...?

I used MIDI-OX and only one of my 3 interfaces worked for it (or maybe 2, if I used 'special settings').
That is all years in the past though. Don't have the info handy...

Good luck! "Bald is Beautiful" :mrgreen
 
Got a new usb-port installed. Same problem. Any way to roll back the firmware or reset the unit to factory settings? Maybe it's something wrong with the last firmware installed? I don't know. Worth a shot!
 
You must log in or register to reply here.
Back
Top Bottom