After reading some discussion about using tweaked guitar amp models with bass, I dug into the subject of Marshall amps a bit, and realised that the Super Bass versions of some of the amps already modelled by Fractal only have a few components which differ from each other.
It would be awesome if these were included by default. It shouldn't be too hard to change a few component values in the modelling code, right?
Also related to this: Does someone know if one of the already available tone stack types matches what e.g. the 1992 JMP Super Bass has? I guess tweaking the frequencies in the tone stack setting should also do the trick...
I'm thinking most of the changes should be implementable by tweaking the tone stack frequencies, and adding some pre-PA eq to compensate for the smaller capacitors feeding the power tubes in the guitar models, but would be nicer if this was available out of the box!
It would be awesome if these were included by default. It shouldn't be too hard to change a few component values in the modelling code, right?
Also related to this: Does someone know if one of the already available tone stack types matches what e.g. the 1992 JMP Super Bass has? I guess tweaking the frequencies in the tone stack setting should also do the trick...
I'm thinking most of the changes should be implementable by tweaking the tone stack frequencies, and adding some pre-PA eq to compensate for the smaller capacitors feeding the power tubes in the guitar models, but would be nicer if this was available out of the box!