dry (tuner out) signal and S/PDIF out at the same time

[stefenator]

posted this already, but it looks like the forum crashed and so I guess I have to try it again...

I know that once I get my head around this I'll be fine, but I'm trying to get an unprocessed, dry signal out of one of the outputs and then S/PDIF direct into the FOH.

Is this possible?

Thank you in advance for any help you can provide...

Steph

 

[javajunkie]

Yes, put an fx loop block in the first column, not connected to any thing, and your dry signal will come out output 2.

 

[stefenator]

Thanks Sean!

in the editor that is the "Feedback Send" block correct? and I only need a line from the input to it and from it to the output, correct? I just want to make sure I understand it completely.

Thanks again!

Steph

 

[javajunkie]

Thanks Sean!

in the editor that is the "Feedback Send" block correct? and I only need a line from the input to it and from it to the output, correct? I just want to make sure I understand it completely.

Thanks again!

Steph

No, Effect Loop block. No on the routing. If you place it the first column it will automaticallly connect the input. Don't connect anything to the right side, just turn up the knob on output 2.

 

[stefenator]

Sean,

so in the editor, that's the block simply labeled "loop?"

I'll give it a try. Thanks again for your help!

Steph

 

[javajunkie]

Sean,

so in the editor, that's the block simply labeled "loop?"

I'll give it a try. Thanks again for your help!

Steph

yes, in the editor it is labeled loop.