DAW USB Audio Output very low compared to guitar output on OUT1

R

RomanMtz

Member
So I just got my Axe 3 last week and I'm trying to replace my current recording setup with it. I fired it up, updated the FW and it works great. The only issue I'm having is that my previous recordings on Studio One sound way too low (mixer levels seem fine). The guitar outputs fine, but when I press play on a previously recorded track, it sounds too low. I can crank the out 1 knob, but then the guitar signal is way too high.

I tried recording a new track and it tracks fine (gain on all channels -12), but when I play back, output is low again...

I tried searching the forums and the manual but couldn't find any solutions. Any suggestions? Thanks in advance!
 
Thanks for the responses guys and I apologize... I had seen these posts but when I went to that setup page I didn't touch it cause it was labeled USB input levels (and not return or output) and I thought it had to do with guitars being reamped into the axe and not the actual output.

Anyway... sure enough, I adjusted these and it fixed the problem. Thanks again!

Roman
 
You must log in or register to reply here.
Back
Top Bottom