Sleestak
Power User
Greetings!
I'm setting up my new FC-12 and am experiencing a problem with a momentary control switch. On the FC-12, I have set up a momentary CS that is tied to Output 3 in the patch. Output 3 goes to my Frequout pedal, which then comes back to the AxeFX III via Input 3. My desired behavior is that (1) the preset loads with Output 3 bypassed, and the light ring around the assigned FC button reflects this by being dimmed. When I press the button on the FC, I want Output 3 to be unbypassed, and the light ring to be bright. Then when I release, it should go back to the initial state (bypassed, light dim).
Here is what's happening:
I'm setting up my new FC-12 and am experiencing a problem with a momentary control switch. On the FC-12, I have set up a momentary CS that is tied to Output 3 in the patch. Output 3 goes to my Frequout pedal, which then comes back to the AxeFX III via Input 3. My desired behavior is that (1) the preset loads with Output 3 bypassed, and the light ring around the assigned FC button reflects this by being dimmed. When I press the button on the FC, I want Output 3 to be unbypassed, and the light ring to be bright. Then when I release, it should go back to the initial state (bypassed, light dim).
Here is what's happening:
- When I first load the preset, Output 3 is disabled. This is what I want, so all good there. However, the light ring around the FC button for that control is LIT, suggesting that it "thinks" it's engaged, which it is not.
- The first press of the FC button does nothing. The light ring remains on. If I'm monitoring the controller value in Axe-Edit, I can see that no change is being transmitted. The value for that controller is not changing.
- Upon release of the button, the light ring goes off and the control value remains unchanged.
- All subsequent presses of the button work as expected: light comes on while depressed, and the value toggles appropriately.