Hello Everyone,
Welcome to the master thread for Cherry Sun Sounds IR's.
Each shot was taken on various points of the speaker in a pseudo DynaCab™ fashion and how I go about micing cabs in the studio. I fine tune the low end to my taste with the distance from the speaker, then File Numbers 01, 02, 03...etc. are the microphones speaker position from the cone to edge for high end brightest to darkest.
For the “Standard Ribbon/Dynamic Mic Combo” use a “…07.wav” file mixed with the “…CLOSE_CENTER.wav” of the Ribbon Mic captures. The “…CLOSE_CENTER.wav” captures are centered on the cone and real close to the grill cloth using the Royer™ AxeMount™ Dual Microphone Clip.
The “Room” captures are at ear height sitting in a chair about 6-8 feet away depending on the cab. Panned left and right is a nice room effect.
Mics
Dynamic:
57m - Based on a modified modern Shure™ SM57
UIII - Based on a vintage Shure® Unidyne III SM57
M88 - Based on Beyerdynamic™ M88
Ribbon:
121 - Based on a Royer™ R-121 (added only to packs 3,4, and 6 listed below and on all future releases)
VR2 - Based on sE Electronics™ VR2 (If it's good enough for John Petrucci, it's good enough for me)
Condenser:
CC8 - Based on Austrian Audio™ CC8
All captures are 24bit 500ms MPT (Minimum Phase Transformed)
Feel free to ask questions or request Cab/Mic Combos in this thread or on the form in the "Shop" section of the website.
Attached are 2 of the 3 Room Mic captures from the 2x12 RCTO pack and an AxeFx III preset and IR from the Decennium 1x8 Cab Pack used on guitar and bass in the video below.
For those that grabbed the now defunct free packs I posted in the "User Cabs and IR's" forum, these are identical except I have added 121 and Room files for the RCTO V30 2x12, Prince GA64 1x12, and Prince Blackhawk A 1x12 Packs. Sounds like everyone has been enjoying them. I will continue to post test files and other freebies occasionally of what I am working on.
If you are in Southern California and have a cab or combo you want captured, message me here or through the website with what you have and we can see what we can work out.
Cliff has Impedance Curves for a few of these cabs now, hopefully they make it into a future Firmware release soon...
Enjoy!
Ryan
1. Decennium 1x8 Cab Pack is based on a Peavey™ Decade™
2. 67 Band Utah 2x12 is based on a 1967 Fender™ Bandmaster™ 2x12 Cabinet with 2 1970 Utah™ Speakers. The Orange Label “In Utero Speakers”
3. Prince GA64 1x12 is based on a Fender™ Princeton Reverb™ with the speaker baffle recut to house a 12” speaker. This one is loaded with an Eminence™ GA-SC64™ 12” George Alessandro™ Speaker.
4. Prince Blackhawk A 1x12 is based on a Fender™ Princeton Reverb™ with the speaker baffle recut to house a 12” speaker. This one is loaded with a Warehouse Guitar Speakers™ Blackhawk Alnico™ 12” Speaker. A favofite combination of Ben McLeod of All Them Witches.
5. Prince Utah 1x12 is based on a Fender™ Princeton Reverb™ with the speaker baffle recut to house a 12” speaker. This one is loaded with a 1970 Utah™ Speakers. The Orange Label “In Utero Speakers”
6. RCTO V30 2x12 is based on a Mesa Boogie™ Rectifier Cabinet™ loaded with a “Holy Grail UK Made T3445” 70w Celestion Vintage 30™ Speakers.
7. 1695T 1x12 is based on a Supro™ Black Magick Reverb loaded with their BD12™ (Made by Eminence) Speaker.
8. 57m Vol.1 - A compilation of 1 57m capture from packs 1-7 listed above.
9. Pano 1x10/1x15 is based on a Fender™ Pano Verb™. Both the 10” and 15” speakers were captured with all the mics.
10. RCTO G12M 2x12 is based on a Mesa Boogie™ Rectifier Cabinet™ loaded with 1998 UK made Celestion™ T1220 Greenback Speakers featuring the “6402” cones.
Welcome to the master thread for Cherry Sun Sounds IR's.
Each shot was taken on various points of the speaker in a pseudo DynaCab™ fashion and how I go about micing cabs in the studio. I fine tune the low end to my taste with the distance from the speaker, then File Numbers 01, 02, 03...etc. are the microphones speaker position from the cone to edge for high end brightest to darkest.
For the “Standard Ribbon/Dynamic Mic Combo” use a “…07.wav” file mixed with the “…CLOSE_CENTER.wav” of the Ribbon Mic captures. The “…CLOSE_CENTER.wav” captures are centered on the cone and real close to the grill cloth using the Royer™ AxeMount™ Dual Microphone Clip.
The “Room” captures are at ear height sitting in a chair about 6-8 feet away depending on the cab. Panned left and right is a nice room effect.
Mics
Dynamic:
57m - Based on a modified modern Shure™ SM57
UIII - Based on a vintage Shure® Unidyne III SM57
M88 - Based on Beyerdynamic™ M88
Ribbon:
121 - Based on a Royer™ R-121 (added only to packs 3,4, and 6 listed below and on all future releases)
VR2 - Based on sE Electronics™ VR2 (If it's good enough for John Petrucci, it's good enough for me)
Condenser:
CC8 - Based on Austrian Audio™ CC8
All captures are 24bit 500ms MPT (Minimum Phase Transformed)
Feel free to ask questions or request Cab/Mic Combos in this thread or on the form in the "Shop" section of the website.
Attached are 2 of the 3 Room Mic captures from the 2x12 RCTO pack and an AxeFx III preset and IR from the Decennium 1x8 Cab Pack used on guitar and bass in the video below.
For those that grabbed the now defunct free packs I posted in the "User Cabs and IR's" forum, these are identical except I have added 121 and Room files for the RCTO V30 2x12, Prince GA64 1x12, and Prince Blackhawk A 1x12 Packs. Sounds like everyone has been enjoying them. I will continue to post test files and other freebies occasionally of what I am working on.
If you are in Southern California and have a cab or combo you want captured, message me here or through the website with what you have and we can see what we can work out.
Cliff has Impedance Curves for a few of these cabs now, hopefully they make it into a future Firmware release soon...
Enjoy!
Ryan
1. Decennium 1x8 Cab Pack is based on a Peavey™ Decade™
2. 67 Band Utah 2x12 is based on a 1967 Fender™ Bandmaster™ 2x12 Cabinet with 2 1970 Utah™ Speakers. The Orange Label “In Utero Speakers”
3. Prince GA64 1x12 is based on a Fender™ Princeton Reverb™ with the speaker baffle recut to house a 12” speaker. This one is loaded with an Eminence™ GA-SC64™ 12” George Alessandro™ Speaker.
4. Prince Blackhawk A 1x12 is based on a Fender™ Princeton Reverb™ with the speaker baffle recut to house a 12” speaker. This one is loaded with a Warehouse Guitar Speakers™ Blackhawk Alnico™ 12” Speaker. A favofite combination of Ben McLeod of All Them Witches.
5. Prince Utah 1x12 is based on a Fender™ Princeton Reverb™ with the speaker baffle recut to house a 12” speaker. This one is loaded with a 1970 Utah™ Speakers. The Orange Label “In Utero Speakers”
6. RCTO V30 2x12 is based on a Mesa Boogie™ Rectifier Cabinet™ loaded with a “Holy Grail UK Made T3445” 70w Celestion Vintage 30™ Speakers.
7. 1695T 1x12 is based on a Supro™ Black Magick Reverb loaded with their BD12™ (Made by Eminence) Speaker.
8. 57m Vol.1 - A compilation of 1 57m capture from packs 1-7 listed above.
9. Pano 1x10/1x15 is based on a Fender™ Pano Verb™. Both the 10” and 15” speakers were captured with all the mics.
10. RCTO G12M 2x12 is based on a Mesa Boogie™ Rectifier Cabinet™ loaded with 1998 UK made Celestion™ T1220 Greenback Speakers featuring the “6402” cones.
Attachments
Last edited:

