Can you run 2 seperate signal chains through the FM3, sharing 1 cab?

[guitarno]

As the title says. Use Case: I want to run regular pickups (Input 1) through a "normal" chain, and a completely seperate chain (Input 2) with piezos from the same guitar concurently. Problem is, the FM3 only has 1 cab, right? I do this on an FM9 and have 1 cab with a pair of acoustic IR's just for the piezo path, and another cab for the mag pickups.

With only 1 cab on the FM3, can i have one side (left or right) of the cab with an acoustic IR, and the other for a normal IR and still keep the signal chains seperate?

Thanks for your input!

 

[Moke]

Yes, If everything is Panned correctly, and you isolate the Left and Right outputs of the stereo cab using two Vol/Pan blocks.

 

[Moke]

Here is a routing example of a dual path preset. However, you will need an 'Input 2' block added for your piezo input.

 

[Moke]

Also, If you want to have two separate isolated outputs, you will need to add Out 2. And add blocks for each path, if CPU allows. There are ways to share some stereo blocks and still stay isolated, but it gets a little tricky.

 

[guitarno]

Thanks Moke! You Rock!