As the title says, I was wondering if there is any way to get the axe to send the present data, namely, sysex preset data on start up?
It would definitely help my teensy/arduino based foot controller as it is powered on before the axe and sends a request when turned on. (it is powered from its own dc supply that does not run through the afx as I only have a 7 to 5 pin midi cable + power break out... this wouldn't be a problem if I had a 7 pin midi cable, then the controller would be powered through the axe, and I could write in a start up delay... etc..)
Anyway, let me know, I couldn't find it in the manual/ settings!
Thanks!
E
It would definitely help my teensy/arduino based foot controller as it is powered on before the axe and sends a request when turned on. (it is powered from its own dc supply that does not run through the afx as I only have a 7 to 5 pin midi cable + power break out... this wouldn't be a problem if I had a 7 pin midi cable, then the controller would be powered through the axe, and I could write in a start up delay... etc..)
Anyway, let me know, I couldn't find it in the manual/ settings!
Thanks!
E
