Behringer fcb1010 (without UnO mod) volume/wah pedal?

S

SamTLW

New Member
Hey guys i have searched several threads and can't figure it out.

I have reset the fcb1010 to the axe fx by holding 1 and 6. I can select patches 000-100 in bank A.
I can't figure out how to get expression pedal A/B to send midi to the Ultra
Please help finding midi rather confusing!
 
have you tried the 'learning' mode?

press i/o on axe
press page > to 'ctrl' tab
scroll down ro 'external 1' press 'enter' then move pedal

repeat for pedal 2
 
How to set up a WAH with the FCB 1010 and Axe Fx:

First check to see if the FCB is programmed and ready.
When you move the expression pedal on the FCB 1010, two things should be happening:
1. The MIDI IN on the Axe Fx should light up (indicating the Axe Fx is receiving a midi signal).
2. The display on the FCB should change from 0-127.
If these two things are happening, then do this:

On the Axe, press I/O and PAGE over to the CTRL page.
Scroll down to EXTERNAL 1 and press ENTER.
Now move your expression pedal from 0-127.
Scroll down to EXTERNAL 2 and press ENTER.
Now move the other expression pedal from 0-127.
Press the RECALL button.


In a WAHWAH effect block, go to FREQ and press ENTER.
Set SOURCE to EXTRN 1.

Play VooDoo Chile. This works for the wah
 
When you move an expression pedal, does the MIDI IN light up on the axe fx?
If it lights up then do this:

press I/O
page over to the MIDI page
set MIDI CHANNEL to OMNI

then see if "learning" mode works
 
You must log in or register to reply here.
Back
Top Bottom