I have watched main 2 youtube vids for setting up non-chipped FCB to run axe and also read forum posts here over and over, but I am still stuck after 30 days and have one more night to get this up and running or I have to return to GC tommorrow......The only things I want to do with this unit are to change patches, have a few effects turn on and off, and use the expression pedals...I think I have the expression pedal thing down but was wondering if there was anyone who could post a simple and exact process to get the other things working.I am an absolute midiot and while one of the posts here was very thorough on setting this up I found that the explanation just added to the confusion as I didn't get a lot of things mentioned there.Any help would be appreciated, thanks......I am also wondering if after updating firmware you have to do the setup configuration over for the FCB.I guess the simplest route to go if I can't get setup by then is to get a Midi Moose and an expression pedal, which as far as I can tell both of these can be used at the same time with the Axe.The only thing I couldn't do then would be to turn a few effects on and off within patch