Axe not sending FC layouts

[edwinstar]

Since the latest Firmware, my Axe-Fx III doesn‘t send a selected FC-12 layout (selected via Axe Edit) to the Floor unit. I have to select it from the FC-12.
Also when i turn off the Axe Fx, next time i turn it on, it doesn‘t show the previosly used FC layout, but an older one that i‘ve been using before the new one.
Is there a new setting that i missed?
Thanks!

 

[Rex]

There's no new setting, but make sure the Startup Layout is set to the layout you want to start on.

 

[edwinstar]

Ok, i will do that, thanks! But what about Axe Edit not being able to switch the layout? I used to do that all the time when working on different layouts.

 

[chris]

Ok, i will do that, thanks! But what about Axe Edit not being able to switch the layout? I used to do that all the time when working on different layouts.

There are buttons below the Layout name. Make sure the one you want is on, probably FC1.

 

[Rex]

Ok, i will do that, thanks! But what about Axe Edit not being able to switch the layout? I used to do that all the time when working on different layouts.

 

[edwinstar]

Aha! Thanks, i think that‘s it!