And HX FX for that matter...
If you had a Kemper and an Axe FX II +, how would you wire them up?
I'm planning on going guitar - any incidental pedals like the Klon Klone or the little tube preamp - Fractal, then put the Kemper in the loop.
BBE would go on the stereo outputs.
Kemper monitor out might go to a center dry channel. Maybe.
Are there any "best practices" or "try this" suggestions?
(It's taken me a while to start using this thing - I was crushed that the III came out right after I got this thing, been ignoring it for quite a while now.)
Wired it up just as a compressor - think I must be doing something wrong.
If you had a Kemper and an Axe FX II +, how would you wire them up?
I'm planning on going guitar - any incidental pedals like the Klon Klone or the little tube preamp - Fractal, then put the Kemper in the loop.
BBE would go on the stereo outputs.
Kemper monitor out might go to a center dry channel. Maybe.
Are there any "best practices" or "try this" suggestions?
(It's taken me a while to start using this thing - I was crushed that the III came out right after I got this thing, been ignoring it for quite a while now.)
Wired it up just as a compressor - think I must be doing something wrong.