ethrbunny
Inspired
(firmware 7 - I'm holding off on 8 until AE is done)
Made a patch. Added 'wah1'. Clicked on the 'controller' and set 'source controller' to 'envelope'.
This does what I would expect it to. So I save it and move to another patch.
Later I come back to this patch and find that the 'autowah' is on. Looking at it I see that neither the MFC, nor the AFX thinks its on.
So I click it to 'on'. No change. Then I click it 'off'. Still no change. Still wah-ing away.
I try to change the source controller to something else. Then I change it back to 'envelope'. It turns on and off as I would expect (via AE, MFC, or AFX). But if I save this patch, change to another and come back, its on again - even though it isn't.
The only way to make it stop is to remove the effect from the patch altogether.
Made a patch. Added 'wah1'. Clicked on the 'controller' and set 'source controller' to 'envelope'.
This does what I would expect it to. So I save it and move to another patch.
Later I come back to this patch and find that the 'autowah' is on. Looking at it I see that neither the MFC, nor the AFX thinks its on.
So I click it to 'on'. No change. Then I click it 'off'. Still no change. Still wah-ing away.
I try to change the source controller to something else. Then I change it back to 'envelope'. It turns on and off as I would expect (via AE, MFC, or AFX). But if I save this patch, change to another and come back, its on again - even though it isn't.
The only way to make it stop is to remove the effect from the patch altogether.