atomic reactor 50w - changing tubes

[rolidoc]

who knows the regular bias adjustments (value) for the atomic reactor 50 w, please help!

 

[Tom King]

Hi rolidoc,

The bias should ideally be between .74-.76v at the test point. Hope this helps.

-TK

 

[rolidoc]

Hi Tom, thank you! I need this information for my technician, I´m only a musician, so two little question: .74 means 0,74, right? What is v, maybe Volt? Thank you again

 

[Ole]

On our voltmeters here in germany it is most likely in miliVolt (mV) so that would be between 740-760 mV.
But yes the .74 is 0.74 and V is Volt
Make sure your Atomic has been on for 15-20 min when you adjust the Bias.

 

[rolidoc]

thank you Ole, i will try it Sunday

 

[NMG]

Are any additional componants required for testing or can the test point be accessed just like the bias trim can?
I know usually the test is done by measuring the voltage across a resistor. .
Not getting ant info from Atomic.

 

[NMG]

Its ok, I have all the info I need.