Anyone using a digital power amp?

[flynv]

Here's what I've found:
If I'm running FOH and an FRFR monitor I have a set of patches for that
If I'm running to a cab (with the cab sims disabled) it's either a situation where the venue is small or I mike the cab (usually a 1x12).

I've always had at least 2 sets of patches one for home and one live. Now with the ability to disable the cab sims.......I have 3 sets.
It's not that big of a pain when you get used to doing it.

 

[SEKKEN]

Are you sending sound including the cab to the powerstage, or do you have the FX loop block before the cab?

I've placed the FX loop just before the cab block so no cab sim runs into the powerstage.

 

[blackmoreguitar]

I've placed the FX loop just before the cab block so no cab sim runs into the powerstage.

That's how I do it too; I don't worry about anything else and as the power stage has eq I would just use that to tweak the cab tones. I also enjoy just using FRFR; a have a CLR which is pretty great.

 

[SEKKEN]

That's how I do it too; I don't worry about anything else and as the power stage has eq I would just use that to tweak the cab tones. I also enjoy just using FRFR; a have a CLR which is pretty great.

I'm doing exactly the same: I use powerstage + cab on output 2 and frfr (and FOH) on output1. Best of both words in my opinion. I'm just trying to figure out which parameters i should tweak on the amp block to better match the powerstage. Yesterday I was in the room with the band, I tried raising the SAG to 6 and tweaking the low resonance freq... it really seems to do the job ;-)