Attach the preset so we can look at it.I am using the same IR for all scenes too?
Yes, I just noticed noise when switching scenes if I have sound from guitar or fx trailing as I switch {all presets I tried this on}I am using the same IR for all scenes too?
But if run 2 amps blocks in series, would this not mute the pass through sound? I only use 1 amp block at a timeNo problems here. If you're bypassing an amp, make sure it's bypass mode is set to MUTE.
One would generally NEVER* run two amps in series. It's not a good idea on the Axe-Fx or with traditional tube amps, I should dare say.But if run 2 amps blocks in series, would this not mute the pass through sound? I only use 1 amp block at a time
Always put them in a parallel row, with the bypass states set to 'Mute'But if run 2 amps blocks in series, would this not mute the pass through sound? I only use 1 amp block at a time
This is likely the culpritAlways put them in a parallel row, with the bypass states set to 'Mute'
If they are in series, both could possibly be 'on' at the same time for a very brief moment when switching between them, causing a quick burst/pop.