Fixed Amp block - Toggling SIC curves

[Steven Persson]

I've reverted to Legacy IR Cabs for a while and noticed a problem when toggling the SIC with keyboard arrows in the AMP Block.

I tried this with existing presets and a completely new preset.

When adding the AMP block, the default SIC is the Dynacab 5153 (since it's the last amp I was mocking around with). Turning that "Auto-Dyna-Cab Imp" off to choose a "legacy" SIC and toggling the legacy SIC with the keyboard arrows, the up arrow on my keyboard only toggles between "Resistive Load" and "Oxbow Load" while the down arrow only toggles "1x8 5F1 Tweed" and "4x10 Bassguy". So I assume somethings broken here as this behaviour is present with the just installed and latest Axe Edit as well as the previous version of Axe Edit.

Can someone replicated this behaviour?

 

[Steven Persson]

No body else with this problem?

 

[sgplayer76]

Mine does the same thing. I need to update to 24.04 - I’ll report back after I’ve had a chance to update and play (later this evening).

Update: Still there after updating to 24.04.

 

[State of Epicicity]

I've found this too.

 

[Steven Persson]

Unsure if this is a firmware related problem or an Axe Edit one? @FractalAudio @Michael Pickens

 

[yek]

Is this fixed? Can't reproduce the issue with FM3-Edit.

 

[ProfEmerald]

Same issue here. Has been this way for a while, not sure when it started.

 

[Steven Persson]

Is this fixed? Can't reproduce the issue with FM3-Edit.

It's fixed in the Axe Edit. The latest release solved it. Can't speak for FM Edit though.