Adding a second Drive and assigning an IA question...

[DBrianinAZ]

Hello forum.

I am attempting to add a second Drive block to several presets and want to assign IA switch 16 for this purpose--I cannot seem to figure out how to make it work this way. I am also trying to get the Looper to work in a few presets and even though I have added a looper block and have programmed the MFC to go into looper mode with a long hold, it says I do not have a looper function in this preset. Thanks for any suggestions!!

I am running the most current FW in everything...

Cheers!!

 

[brokenvail]

Are your using an MFC? It is painless to set up drive two with MFC


Sent from my iPhone using Tapatalk

 

[jdosher]

Do you have the MFC in the right mode to talk bidirectionally to the Axe? I assume so, but it sounds like you're having some odd behavior where the Axe and MFC aren't communicating properly.

 

[DBrianinAZ]

Yes I am using the MFC with the latest FW version and I have it programed to go into Looper mode after a long hold on the reveal IA

Are your using an MFC? It is painless to set up drive two with MFC


Sent from my iPhone using Tapatalk

 

[DBrianinAZ]

Hello,

I am not sure what you mean other than I have configured the Lopper to be accessed after a long hold on the reveal IA