control switch

  1. Dyersbrew

    Bug? Control Switch Issue with FM3/FC-6 Configurations

    I’m experiencing an issue with control switches assigned as momentary on the FC-6 when connected to an FM3. I use an FM9 as my primary unit and FM3 as my backup. I use them in 1 of 3 configurations. Config 1: FM9 standalone. Config 2: FM3/FC-6 as OMG9. Mimics Config 1 layout and workflow...
  2. F

    Initial control switch state

    I use a control switch assigned to a latching switch on my FC-12 for switching between two signal paths of my presets. When I power up my FX III, the control switch is always disengaged. Is it possible to configure the control switch globally (i.e., for all presets) so that it is engaged by...
  3. Z

    Can I change scene in momentary mode?

    Hello guys, there's a way to change scene in momentary mode?
  4. JrBean

    [solved] CS on bottom right button when set to momentary

    I think I have found a bug on the FC-12 with my Axe FX iii Mk 2. If I set the bottom right footswitch to be a momentary control switch, it does not function. This occurs in any layout, and with any control switch. I have the hold function unassigned, and have reset it just in case. I can swap...
  5. Tomas Kamensky

    Wish Global clean boost controlled by internal switch

    Hi, it would be great to add the ability to control output level by internal switch. Output (Setup > MIDI/Remote > Other - Output 1 Volume) can only be controlled by PEDAL, FC PEDAL, FC SW or CC. It would be great if it could be controlled by an internal switch (Control Switch?) and so it would...
  6. 1

    One Control Switch for latching and momentary

    No question, just my findings, which others may have already found out... I reserved a button for Control Switch 1 (latching) in my main layout. The hold function of that button is also CS1 (but momentary). Depending on my mood and need, I can use it to operate a special function in each...
  7. gekomax

    Control Switch scene ignore

    hi folks, is there something like scene ignore for control switches? What I want to achieve is that CS doesn't change when I change scene on FX3. Is it possible? Thanks Gekomax
  8. C

    Change channel with control switch?

    Is it possible to change a block's channel with a control switch? Sometimes, I want to change the reverb block channel for all scenes. Control switches allow changes to persist when you switch between scenes. Otherwise, every time I switch scenes, I'd have to set the reverb block's channel...
  9. Les Paul Rider

    Doubts about functions on the control switch.

    Is it possible to control the "play" of the looper with a control switch? I'd like to press a button to start the looper and switch to the next scene at the same time. Is it possible? and another question, is it possible to change blocks with a control switch, not changing scenes? For instance...
  10. C

    Help with Modifiers, Control Switches, & FC layouts

    Hi all, appreciate any guidance on the below items. I have searched through the manuals, but I am not confident too say that I may have overlooked something. I am looking at doing the following: 1. I would like to have a Control Switch mapped to an FC layout that would switch between an active...
Back
Top Bottom