Search results for query: *

  • Users: TubeAmpNut
  • Content: Threads
  • Order by date
  1. TubeAmpNut

    (SOLVED) Feedback Send/Return FW21.01

    Not sure if this recently broke with 21.01 or earlier, but I noticed my patches where I send a signal back using the feedback send/return seem broken (the feedback blocks). Would anyone mind cooking a simple patch with feedback through a phaser or pitch block then back into the delay and verify...
  2. TubeAmpNut

    Plus Distortion Broken? FW19.05

    Not sure if this is a regression or it's been busted a long time but the Plus Distortions model is so quiet I thought it was passing no sound. I figure around 18db quieter compared to the Rat Distortion model. I've tried changing other models to the 1N270 rectifier (although it makes the other...
  3. TubeAmpNut

    Mute Output 1/2 while listening to headphones?

    Something I couldn't get out of the 2XL+, I'd like to mute the output to the near fields (without having to power them off...) to record acoustic guitar. Naturally I'd like to listen to the playback through headphones. Is this routing option available in the III?
  4. TubeAmpNut

    When you need real tubes glowing...

    I only build amps for fun (but they are far more complicated than the average homebrew) and for finding that tone that i couldnt get out of other maker's amps, but that obsession took a few years off when I got my axe ultra and ii the past few years. Well I decided to finish this project that...
  5. TubeAmpNut

    Esoteric RCB and ACB Swapped?

    I thought the RCB was supposed to be the "Real Clean" Boost vis "Almost Clean", it appears in the model that RCB has more gain and distortion than ACB. Are these swapped by chance?
  6. TubeAmpNut

    Anyone else find 8.0 stiffer than 7.0?

    Been struggling here with the lower gain stuff since 8.0. The higher gain tones are good, but my beloved 50W plexi patch which had lots of give, bloom and farted in all the right places in v7.0 is as stiff as a kick in the nuts with 8.0. I've rebuilt the patch from scratch and reset...
  7. TubeAmpNut

    Power On Preset?

    When I power on my unit, it always defaults to preset 004. This occurs even though I powered it off on preset 001. Is there a way to change this? It just annoys me! I searched the manual but coudln't find a solution.
  8. TubeAmpNut

    Delay 2 Block Mysteriously Bypasses Itself

    Anybody else have their Delay2 block bypass itself? I even created an empty block with a Delay2 in the chain and it will bypass itself after a minute or two. Firmware 1.5.
  9. TubeAmpNut

    BK's Plexi Presets

    Some folks asked for my plexi presets, so I'll post them here. I like to dial in various circuits over the plexi-era evolution and here is my interpretation of an early '67 Super Lead. The first ones had the JTM45-style tonestack and an open tone (Angus/VH/etc.). I may tweak it a little as...
  10. TubeAmpNut

    Did the Axe II get new knobs?

    They look different on the wiki page than the fractal audio page... There are a few other minor changes too: The pin stripe under AxeFX II , "Output Levels", and "Out1/Out2"
  11. TubeAmpNut

    AxeFX II Lottery

    Why not have a lottery style drawing where people who signed up to be notified of availability will be randomly selected and given the opportunity to buy from the batch that day. If they pass on the opportunity they are removed from the list. This way people that can't sit on the store all day...
  12. TubeAmpNut

    The "Damp" Control is Strange

    Assumption: The Damp control is essentially a power amp negative feedback control. Lower the Damp to zero and you essentially remove the negative feedback from the power section, ala Vox AC-30 and Recto Modern. If this is assumption is true, then the control does not behave like a real...
  13. TubeAmpNut

    Pitch to MIDI Note

    How about pitch to MIDI note out? Allow for pitch detector or pitch block input for intelligent harmony tracking. You could drive bass or other synth plugins for accompaniment live. Maybe enable frequency/pitch selective triggering. BK
  14. TubeAmpNut

    Transformer Saturation (aka GRIND)

    I can't seem to recreate the tone of a crying output transformer, particularly with the plexi models. There is a distinctive tone when the OT core saturates and starts to clip the output waveform. Both the Deluxe and the Plexi models are missing this pleasant artifact of a cranked non-master...
  15. TubeAmpNut

    Ultra V10.01: Pitch Arpeggiator Master Balance

    I don't know if this is a bug, but the Master Balance control of the Arpeggiator (v10.01) appears to be backward. Rotate control 100% to the right and the sound is 100% left, and vice versa. BK
Back
Top Bottom