Narzugon
Power User
I'm wanting to step through both Amp 1 and Cab 1 channels simultaneously via a CS#. Wrapping back around would be a bonus. Is this possible?
As step one of trying to figure this out I have been trying to simply go to a specific amp channel via a CS# assigned to a switch on my FC12. But I'm failing and at this point and have been spinning my wheels for two days. I don't want to use scenes to do this and have engaged Scene Ignore for each channel. I want independent control of the amp/cab channels from scenes.
Axe III and FC12 on latest firmware. Here's where I am so far.
FC Controllers: CS4 set to: CC Ch1 CC#127 On Value 0 Off Value 1
Midi Remote: Channel Amp1 CC#127
FC12: Switch 7 set to: Control Switch Latching CS4
I'm using CC#127 only because I couldn't find the Midi Table like we had for the MFC's. When I press FC switch 7, nothing happens. Even if it did, how would I get it to cycle through the Amp Channels?
Is there a better way to do this?
Any help appreciated!
As step one of trying to figure this out I have been trying to simply go to a specific amp channel via a CS# assigned to a switch on my FC12. But I'm failing and at this point and have been spinning my wheels for two days. I don't want to use scenes to do this and have engaged Scene Ignore for each channel. I want independent control of the amp/cab channels from scenes.
Axe III and FC12 on latest firmware. Here's where I am so far.
FC Controllers: CS4 set to: CC Ch1 CC#127 On Value 0 Off Value 1
Midi Remote: Channel Amp1 CC#127
FC12: Switch 7 set to: Control Switch Latching CS4
I'm using CC#127 only because I couldn't find the Midi Table like we had for the MFC's. When I press FC switch 7, nothing happens. Even if it did, how would I get it to cycle through the Amp Channels?
Is there a better way to do this?
Any help appreciated!