BrickGlass
Inspired
So I've noticed that on some of my clean presets, the wah, when rocked all the way forward, will cause the out 1 clip to the hit the red and the sound will distort a bit. Typical crackly sound when clipping occurs. I'm using the Clyde or the Cry Babe on cleans. Using a Mission pedal. On distorted or lead tones I typically go with the Color-Tone or Mortal and they never hit the red on out 1 clip, even if I strum hard. All my presets are leveled using the VU meter in the utility menu. When in the utility menu the Color Tone and Mortal don't really go past the line in the VU meter. They hit pretty much exactly where it does with the wah off. However, with the Clyde and Cry Babe it goes WAAAY beyond the VU line when the pedal is forward. Is there any particular parameter in the wah block that helps this? Frequency Max? Drive? I've messed around with them but nothing seems to help...except the level in the block. If I lower the level to around -9db then it works ok and goes to roughly the line in the VU meter. I seem to lose a decent amount of volume when I lower it that far though, at least perceived volume. I'm on the latest firmware and am aware of the recent wah changes.