racetra
Inspired
I have been looking but havent found what I am lookin for. I want to be able to change the channels on my blackstar when I change patches on the MFC. I am running the 4CM and want to have 4 similar Patches with different amp channels. I am not sure where to go in the MFC. The manual for the amp says"The controller should be set to transmit program change messages. New it is set to OMNI mode and responds to program change messages on all MIDI channels" I dont know much about MIDI so thats all greek to me.
I am guessing I will just hook a MIDI cable from the Out/Thru on the Axe to the in on the amp. then I would go into the MFC and set something to deal with the program change.
Any help would be great.
Kris K, ya out there?
I am guessing I will just hook a MIDI cable from the Out/Thru on the Axe to the in on the amp. then I would go into the MFC and set something to deal with the program change.
Any help would be great.
Kris K, ya out there?