USB OUTPUT VOLUME WITH ACUISTIC *HELP*

[Stevelow74]

Hello to All!!!!

I looked around the forum for this topic but can really find an answer.

I'm tring to rec via USB my MATON with a Piezo system that DON'T have any type of regulation on board. Playing live I never had problems with volume.
Recording with other interfaces everything Ok. With Axe2 I CAN'T get the Volume, the meters on the Wet just don't move. I tried with Scotts sugestion and I pick up a piezo patch posted recently, but nothing can get the volume..... is there something that I can try?

THANKS AND ROCK ON!!!!!!!

 

[Raca]

You have to set a high ouput level on your preset.
For example the factory presets are too low for USB audio and you have to raise the Amp block Level to get a decent audio level on USB.
Be careful to stay below clipping.

 

[Stevelow74]

So do I use the globel or the amp block level?
But what I don't get is that most are not even using the amp block with piezo....

 

[DieSchmalle]

Put a filter block at the end of the signal chain and raise the level parameter.

 

[Raca]

No need for a filter block. If your preset doesn't have an Amp block, use the Main level of your preset (LAYOUT / OUTPUT tab).

 

[Stevelow74]

Fixed I had a problem on the cab block.....
I do still get a big delay while I am un logic to record.