Tone Matching IRs?

[DXMG503]

Sorry if this has been discussed already.

I want to bake some tone matching into my IRs, and I’m wondering what the best way to go about this is? There’s a lot of pros on here who do these.

I’ve tried capturing IRs of my amp EQ section successfully, but I’m not sure how to bake those IRs into a cab IR. I assumed CabLab would let you mix them in series, but it seems the only option is mixing in parallel which doesn’t work for this scenario. You can’t mix them in parallel on the unit either.

I don’t have an Axe III, I’m on FM9, so I don’t have a tone match block. That said, I don’t understand how those with an Axe III bake that block into their IRs anyway.

Any thoughts?

 

[rzjd]

This will start you off. I just use melda to do all of it then import the wav as a cab

 

[DXMG503]

This will start you off. I just use melda to do all of it then import the wav as a cab

Thanks for this!

 

[Wizi]

You can record your sound with the IR plus tone match, then use the tone match again without a cab to capture the recording.