Stereo routing help!

C

Captainsexy

New Member
Hi folks! I’m going mad, and can’t find any help..

I want to run a Keeley Halo in stereo to input 3 and out to output 1 in stereo. But now I’m only getting mono from output 1. I can see the that Axe is getting left and right signal from input 3, but goes mono out from output 1..

The chain is: pedalboard-amp-Suhr reactive load-Keeley Halo-input 3-IR-output 1.

Sorry if this have been asked before.
 
Is your Cab block Input Mode set to Stereo?

And do you have IRs in both slots?

Press the front panel Page right button a couple of times to get to the Meters view and see where the signal is going to mono.
 
You must log in or register to reply here.
Back
Top Bottom