split left and right to different amps?

[slimefuzz]

2 applications that might have the same answer
What would be the most efficient way to do these?

1. Split stereo effects into left and right that go to separate amps and cabs (internal)
2. Use out3 and in3 as separate send returns with different external pedals on left and right,
then send those to separate signal paths (internal)

Thanks

 

[sprint]

1. Split stereo effects into left and right that go to separate amps and cabs (internal)

I do this often > stereo fx before dual duplicate parallel amps hard panned Left / Right with one set to input Left and the other set to input Right, then going into a Cab block with stereo input and dual hard panned IRs - works great.

2. Use out3 and in3 as separate send returns with different external pedals on left and right,
then send those to separate signal paths (internal)

works if you don't need them both to be active at the same time in series: one pedal in the loop's left path and the other pedal in the loop's right path, then use a mixer block with 3 switchable channels: one for no loop (both pedals off), one receiving input from the loop with row balance hard left (pedal 1), and one receiving input from the loop with row balance hard right (pedal 2).

using these techniques on Ax3 - should work on FM9. wrt efficiency, these are the only ways I know of, so most efficient.

 

[slimefuzz]

That helps a lot :}